Proxim ORINOCO AP-2000 User Manual Page 134

  • Download
  • Add to my manuals
  • Print
  • Page
    / 244
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 133
134
Using the Command Line Interface (CLI)
Bootloader CLI
The Bootloader CLI is a minimal subset of the normal CLI used to perform initial configuration of the AP. This interface
is only accessible via the serial interface if the AP does not contain a software image or a download image command
over TFTP has failed.
The Bootloader CLI provides you with the ability to configure the initial setup parameters as well as download a
software image to the device.
The following functions are supported by the Bootloader CLI:
configuration of initial device parameters using the set command
show command to view the device’s configuration parameters
help command to provide additional information on all commands supported by the Bootloader CLI
reboot command to reboot the device
The parameters supported by the Bootloader CLI (for viewing and modifying) are:
System Name
IP Address Assignment Type
IP Address
–IP Mask
Gateway IP Address
TFTP Server IP Address
Image File Name (including the file extension)
The following lists display the results of using the help command in the Bootloader CLI:
Figure A-1 Results of “help” bootloader CLI command
The following lists display the results of using the show command in the Bootloader CLI:
Figure A-2 Results of “show” bootloader CLI command
Page view 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 243 244

Comments to this Manuals

No comments