Quick Install Guide Tsunami MP.11 Model 5012-SUR Version 3.0.1 Part Number: 73226 (CD version) 73227 (Print version)
Page 10 Copyright © 2006 Proxim Wireless Step 3: Mount Unit to PoleMount the 5012-SUR to a pole as follows:Using a screwdriver, turn the screw on the
All rights reserved Page 11Repeat procedure to attach other band clamp through bottom opening in the 5012-SUR unit. Note: Do not fully tighten band c
Page 12 Copyright © 2006 Proxim Wireless Step 4: View LEDs/Adjust MountingLEDs are located in the cable compartment.When the unit is powered on, the
All rights reserved Page 13Step 5: Close Cable CompartmentEnsure that the Ethernet cable is properly routed and exiting the unit through the notch at
Page 14 Copyright © 2006 Proxim Wireless The assembly with the cable cover attached is shown below.
All rights reserved Page 15Step 6: Tighten Band ClampsUsing a 5/16” nutdriver or a screwdriver, fully tighten both band clamps (maximum torque 50 kg-
Page 16 Copyright © 2006 Proxim Wireless Step 7: Install Documentation and SoftwarePlace the CD in a CD-ROM drive. The installer normally starts aut
All rights reserved Page 17INITIALIZATIONConnecting to the unit requires either:A direct physical connection with an Ethernet cable or with a serial
Page 18 Copyright © 2006 Proxim Wireless Select the unit for which you want to set the IP address and click Change. The Change dialog window is disp
All rights reserved Page 19Accessing the Web Browser To access the unit with a Web browser:Start your Web browser and enter the IP address of the uni
Page 2 Copyright © 2006 Proxim Wireless NOTICESCopyrightCopyright ©2006 Proxim Wireless Corporation, San Jose, CA. All rights reserved. Covered by
Page 20 Copyright © 2006 Proxim Wireless Accessing the Command Line Interface Ethernet PortTo use the CLI through the Ethernet port, you must have a
All rights reserved Page 21DEFAULT SETTINGSSetting DefaultMode of Operation BridgeRouting DisabledIP Address Assignment StaticIP Address 10.0.0.1Subn
Page 22 Copyright © 2006 Proxim Wireless Setting DefaultMulti-Frame Bursting EnabledStorm Threshold Broadcast/Multicast UnlimitedBroadcast Protocol
All rights reserved Page 23TECHNICAL SERVICES AND SUPPORTIf you are having trouble utilizing your Proxim product, please review the Tsunami MP.11 501
www.proxim.com 2115 O’Nel Drive San Jose, CA (408) 731-2700
All rights reserved Page 3CONTENTS Introduction ... 4Key Features ...
Page 4 Copyright © 2006 Proxim Wireless INTRODUCTION The Tsunami MP.11 Model 5012-SUR is a exible wireless outdoor client that let you design soluti
All rights reserved Page 5PACKAGE CONTENTSEach Tsunami 5012-SUR shipment includes the items listed in the following table. Verify that you have rece
Page 6 Copyright © 2006 Proxim Wireless HARDWARE AND SOFTWARE INSTALLATIONNotes: Be sure to read the Release Notes le on the installation CD as it c
All rights reserved Page 7Step 1: Choose a locationTo make optimal use of the unit, you must nd a suitable location for the hardware. The range of t
Page 8 Copyright © 2006 Proxim Wireless Step 2: Attach cablesNote:Depending on your application and location, you may nd it easier to mount the unit
All rights reserved Page 9a switch, hub, or patch panel.Use a cross-over Ethernet cable or adapter if you are connecting the unit to a single compute
Comments to this Manuals