Proxim MP.11 User Manual download pdf (Page 20)

Accessing the Command Line Interface

Ethernet Port

To use the CLI through the Ethernet port, you must have a telnet program, the

CLI password, and the unit’s IP address.

To access the unit through Ethernet on a Windows PC:

Open a DOS command window: from the Windows Start menu, select

Run; enter cmd.

In the DOS window displayed, enter the IP address (for example, telnet

10.0.0.1).

Click OK to start the telnet program; you are prompted for your password.

Enter the password (the default password is public).

Serial Port

In some cases, it may not be possible to retrieve the unit’s IP address. In this

case, you can connect to the serial port by connecting to the unit through the

serial port. You still need the CLI password of the unit. Proxim recommends

you power off the radio and the computer before connecting or disconnecting

the serial cable.

To access the unit through the serial port:

Start your terminal program.

Set the following connection properties; then connect:

COM port: such as COM1 or COM2, to which the unit’s serial

port is connected

Bits per second: 9600

Data bits: 8

Stop bit: 1

Flow control: None

Parity: None

Line ends: Carriage return with line feed

Disconnect and reconnect power to reset the unit. The terminal

emulation program displays Power On Self Test (POST) messages. After

approximately one minute (four minutes if DFS is enabled), you are

prompted for your password.

Enter the default password public.

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Proxim MP.11 User Manual Page 20