Proxim AP-700 User's Guide download pdf (Page 25)

Installation and Initialization AP-700 User Guide

Initialization

The following sections detail how to initialize the AP using ScanTool, log in to the HTTP interface, perform an initial

configuration of the AP using the Setup Wizard, and download the required AP software.

• Using ScanTool

• Logging In

• Using the Setup Wizard

• Installing the Software

Using ScanTool

ScanTool is a software utility that is included on the installation CD-ROM. It is an initial configuration tool that allows you

to find the IP address of an Access Point by referencing the MAC address in a Scan List, or to assign an IP address if one

has not been assigned.

The tool automatically detects the Access Points installed on your network, regardless of IP address, and lets you

configure each unit’s IP settings. In addition, you can use set initial device parameters that will allow the AP to retrieve a

new software to an AP that does not have a valid software image installed (see Client Connection Problems).

To access the HTTP interface and configure the AP, the AP must be assigned an IP address that is valid on its Ethernet

network. By default, the AP is configured to obtain an IP address automatically from a network Dynamic Host

Configuration Protocol (DHCP) server during boot-up. If your network contains a DHCP server, you can run ScanTool to

find out what IP address the AP has been assigned. If your network does not contain a DHCP server, the Access Point’s

IP address defaults to 169.254.128.132. In this case, you can use ScanTool to assign the AP a static IP address that is

valid on your network.

ScanTool Instructions

Follow these steps to install ScanTool and initialize the AP:

1. Power up, reboot, or reset the AP.

2. Double-click the ScanTool icon on the Windows desktop to launch the program (if the program is not already

running). If the icon is not on your desktop, click Start > All Programs > ORiNOCO > AP-700 > ScanTool.

NOTE: If your computer has more than one network adapter installed, you will be prompted to select the adapter that

you want ScanTool to use before the Scan List appears. You can use either an Ethernet or wireless adaptor.

If prompted, select an adapter and click OK. You can change your adapter setting at any time by clicking the

Select Adapter button on the Scan List screen.

ScanTool scans the subnet and displays all detected Access Points. The ScanTool’s Scan List screen appears, as

shown in the following example.

Figure 2-6 Scan List

3. Locate the MAC address of the AP you want to initialize within the Scan List.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 230 231

No comments

Proxim AP-700 User's Guide Page 25