Using Web Interface to Manage the Access Point AP-800 User Guide
Configuring the Device
74
Figure 6-27 Protocol Filter Page
3. Configure the Protocol Filter table. This table is pre-populated with existing Protocol Filters, however, you may enter
additional filters by specifying the appropriate parameters.
• To add an entry, click Add, and then specify the following:
— Protocol Name: Enter the protocol name.
— Protocol Number: Enter the protocol number.
— Filter Status: Select the filter status, select either Block or Passthru from drop-down box.
NOTE: An entry’s status must be block in order for the protocol to be subject to the filter.
— Table Status: Select the Table Status
4. Click Add.
Comments to this Manuals