Proxim ORiNOCO User's Guide Page 36
- Page / 145
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Access Point Features AP-800 User Guide
Configuring the Device
36
• Guard Interval: Guard Interval ensures that distinct transmissions do not interfere with one another. This feature
provides immunity to users. Each user is allotted a time slot to transmit their data and this time slot ends with the
guard interval. This parameter is used to configure the guard interval for the wireless interface.
• Tx Antennas: This parameter enables the transmission antennas. This is configured as bit-mask. Eg: 3 - 011
(binary value) - first and second antennas are enabled. 7 - 111 (binary value) - all three are enabled.
• Rx Antennas: This parameter enables the receiving antennas. This is configured as bit-mask. Eg: 3 - 011 (binary
value) - first and second antennas are enabled. 7 - 111 (binary value) - all three are enabled.
The bottom enclosure of the device will display R and A with specific numbers, where R stands for Radio and A stands for
Antenna.
Ethernet
The Ethernet feature is the most popular physical layer LAN technology because it strikes a good balance between
speed, cost and ease of installation. Because of these benefits it is an ideal networking technology for the computer
users. Using this feature you can view the properties of the Ethernet of your network.
Ethernet Features
• MAC Address: This parameter represents the MAC address of the Ethernet interface.
• Speed: This parameter is used for configuring the speed of the Ethernet interface.
• Transmit: This parameter is used for configuring the transmit mode of the Ethernet interface.
Security
The AP supports the following security features:
• WEP Encryptions
The IEEE 802.11 standards specify an optional encryption feature, known as Wired Equivalent Privacy or WEP, that is
designed to provide a wireless LAN with a security level equal to what is found on a wired Ethernet network. WEP
encrypts the data portion of each packet exchanged on an 802.11 network using an Encryption Key (also known as a
WEP Key).
When Encryption is enabled, two 802.11 devices must have the same Encryption Keys and both devices must be
configured to use Encryption in order to communicate. If one device is configured to use Encryption but a second device
is not, then the two devices will not communicate, even if both devices have the same Encryption Keys.
• 802.1x Authentication
IEEE 802.1x is a standard that provides a means to authenticate and authorize network devices attached to a LAN port.
A port in the context of IEEE 802.1x is a point of attachment to the LAN, either a physical Ethernet connection or a
wireless link to an Access Point. 802.1x requires a RADIUS server and uses the Extensible Authentication Protocol
Decimal Binary Active Antennas Marking of the Enclosure
1 001 First Antenna A1
2 010 Second Antenna A2
3 011 First and Second Antenna A1 and A2
4 100 Third Antenna A3
5 101 Third and First Antenna A3 and A1
6 110 Third and Second Antenna A3 and A2
7 111 First, Second and Third Antenna A1, A2, and A3
- ORiNOCO AP-800 1
- Copyright 2
- Trademarks 2
- GPL License Note 2
- OpenSSL License Note 2
- AP-800 User Guide 7
- Introduction 8
- Core Features of AP-800 9
- Hardware Overview 10
- Prerequisites 12
- System Requirements 13
- Product Package 13
- Optional Accessories 14
- Hardware Installation 14
- Using a Console Port 15
- Install the Antenna 15
- Mount the Unit 15
- Power on the Unit 16
- Initialization 17
- Installing the Software 20
- Update Device 21
- Retrieve From Device 23
- Managing the Access Point 27
- SNMP Management 28
- SSH (Secure Shell) Management 28
- HyperTerminal 28
- ProximVision ES 29
- Password Management 31
- Access Point Features 34
- Ethernet 36
- Security 36
- IP Configuration 43
- TPID Priority CFI VID 45
- Managing the Device 48
- Upgrading the Firmware 49
- Monitoring the Device 51
- Interface Statistics 52
- Network Layer 54
- Web Interface Overview 56
- Error Message 56
- Configuring the Device 57
- Filtering 72
- Management Access Control 86
- System Log 88
- Event Log 90
- Pre-requisites 99
- Viewing the MIB Objects 99
- Configuring the MIB Objects 100
- Global Configuration Mode 101
- General Notes 101
- Log into the AP using Telnet 104
- User Exec Mode 104
- Privileged Exec Mode 105
- Show QoS EDCA Command 109
- Wireless VAP Command 110
- System Information Command 115
- Event Logand ICMP Commands 116
- RADIUS Client Access Command 118
- Interface Statistics Command 118
- Filter-status 119
- Protocol-name 119
- Protocol-number 119
- Again entry-status 119
- Troubleshooting 121
- Symptoms and Solutions 122
- Client Connection Problems 124
- VLAN Operation Issues 124
- Gigabit Ethernet PoE 125
- Recovery Procedures 126
- Related Applications 130
- ASCII Character Chart 131
- Bootloader CLI 132
- Specifications 134
- Advanced Bridging Functions 135
- Security Features 135
- Hardware Specifications 136
- Available Channels 137
- Support Options 142
- Statement of Warranty 144
- Other Information 145
Related products and manuals for Networking Proxim ORiNOCO
Networking Proxim ORiNOCO Installation Guide
(35 pages)
(35 pages)
Networking Proxim ORiNOCO AP-8000 User's Guide
(169 pages)
(169 pages)
Networking Proxim RangeLAN2 7921 User's Guide
(103 pages)
(103 pages)
Networking Proxim ORiNOCO AP-2500 User's Guide
(251 pages)
(251 pages)
Networking Proxim AP-2000 User's Guide
(244 pages)
(244 pages)
Networking Proxim RangeLAN2 7500 User Manual
(141 pages)
(141 pages)
Networking Proxim 7910 User's Guide
(127 pages)
(127 pages)
(9 pages)© 2020, manymanuals.com. All rights reserved. | 2.551 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals